Pard NV007SP Scope Holder Tube Replacement Night Vision Kit

This unit is designed to replace the pard NV007SP tube.

Package includes:

• 1x Universal scope holder USH-46
• 1x Pard Adaptor ring PR-007SP
• 1x Storage case (it’s not designed to fit the camera, it is our own case)
• 1x Silicone grease tube
• 1x 4 coil eye rubber cap
• 1x Lens air pump dust blower

The USH-46 goes over the scope eye relief and it needs minimum 20mm maximum 45mm.

This unit can be connect to 99% of the scopes from eye relief outer with dimension of 40mm to 46.5mm and it will find the centre automatically while you are tightening it.

Details:

Our pard ring length: 15mm

Made of aluminium.

Please note:

This unit will not work on any scopes with shorter ocular less then 25mm between the end of the ocular and the reticle illumination control.

Setup instructions:

1. Have the 007SP & EVC adapter connected, then slip them over the eyebell and tighten almost fully.

2. Digitally zoom-in the 007SP to ×3.5, look through it and manipulate the 007SP until the reticle on-screen is centred both horizontally and vertically.

3. Now fully tighten the EVC adapter.

…it can still pivot slightly, with the multiple ‘fingers’ of the adjustable collet acting like a slightly malleable ball-joint, for fine-tuning.

4. Now back-off the zoom to 0x and you have a perfectly centred 007SP/scope setup.