This unit design to replace the pard NV007 tube
This unit will not work alon you need to connect that to
Its made from aluminium.
The threads size it’s m42 x 0.6 pitch
1. Have the 007 & EVC adapter connected, then slip them over the eyebell and tighten almost fully.
2. Then digitally zoom-in the 007 to ×3.5, look through it and manipulate the 007 until the reticle on-screen is centred both horizontally and vertically.
3. Now fully tighten the EVC adapter.
…it can still pivot slightly, with the multiple ‘fingers’ of the adjustable collet acting like a slightly malleable ball-joint, for fine-tuning.
4. Now back-off the zoom to 0x and you have a perfectly centred 007/scope setup.
This unit will not work on any scopes with shorter ocular less then 25mm between the end of the ocular and the reticle illumination control.