(DO NOT ORDER BEFORE WATCHING THE VIDEOS AND READING THE DETAILS)
GoPro 9, 10, 11 and 12 cannot be used on the scope cam without changing the lens.
In order to use this product as intended, you MUST watch the below video on how to change the lens.
Once the lens has been removed, it can’t be reused again, and your camera can be used only with our lens.
Your camera will be out of warranty if you remove the lens.
DO NOT order our side cam kit or our lens if you are not confident in how to do that. We are not responsible for any damage you may cause to your camera.
Gopro and our Screws are T4 star head no screwdriver or screwdriver bits comes with our kit.
The Gopro 9,10,11, 12 housing will be little larger than added photos looks will be little different too (see other added photos).
you will get our Gopro lens adaptor free when you order our kit with lens (worth £30)
This kit includes:
1x Side-Cam 75% goes to the camera (reflection), 25% goes to your eye (transmission), including a rubber ring and a zero-coil eye rubber cap. Ideal for a professional who aims for better recording quality.
1 x 2-Bar Scope Holder The Two Bar Scope Holder is designed to hold the scope from the body tube and is compatible with our existing camera mounting system.
1 x GOPRO Housing for 9,10,11 + 3 x MUN-1 Allow you to connect GoPro 9-10 and 11 to your side cam (please note that you will not be able to use your action camera directly without changing the lens to 12mm or 16mm focal).
1 x Case The new waterproof case will allow you to store your camera mounting system neatly and safely (only when added lens).
1 x Lens Air Pump Dust Blower for Maintenance of the Side-Cam
This unit can be connected to 99% of the scopes with 25mm, 30mm, and 34mm scope tube diameters. It takes a couple of minutes to adjust and assemble it, and only a few seconds to put it on or take it off.
The advantage of this scope holder is that the camera and scope holder can be installed on any side of the scope and are fully adjustable.
It can be set to approximately a 5° angle in any direction.
The 2 Bar Scope Holder includes: 2B-USH & 2B-UCH
- Cope Tube Holder (34mm ring) + 1x Allen Key and 2x Thumb Screws
- 34 mm to 30 mm Ring Adaptor
- 34 mm to 25 mm Ring Adaptor
- 2x Aluminium Bars (17 mm long)
- 1x Camera/Sidecam Ring + 4x Grab Screws and 1x Allen Key
- 2x Ball Screws
- 2x Ball Grab Screws
Please follow the above pictures to assemble the product